Leviton Z-MAX r24sd, User Manual

Page: 16 / 93

Page 10
Special Instructions for Flush Mount Kit
Installation
Step 1:
Locate where the cabinet will be hung in the wall.
Choose a location in a dry area that is convenient to
the branch circuit panel
Step 2:
Be careful to remove the ground wire from the door.
It is attached using a spade connector. No tools are
required
Step 3:
Remove the door by sliding the door up and off its
hinges. You will have to unlock the door first using
the supplied key
Step 4:
On the 8 Cabinet you will also have to remove the
ribbon cable from the LCD display
Step 5:
Set the door aside in a safe place
Step 6:
Cut out the drywall if needed
Step 7:
Tap out the mounting hole knockouts located on the
sides of the cabinet. See the figure on the next page
for the location of the knockouts on each cabinet
Step 8:
Attach the unit to the wall. Use #10 (with washer)
hardware. 1/4" hardware can be used, but the
mounting holes will need to be drilled out to 5/16"
Step 9:
Install the flush frames as shown in the figure below
using the screws provided
The 24 cabinet is shown, but the process is similar
for the 8 and 48 cabinet.
WEB
VERSION