-76-
3.4 FITTING THE BLADE ENGAGEMENT LEVER
fit the end of the lever (1) on the projecting
part of the pin (2) and fix it all by tightening
the screw (3) and nut (4)
3.5 CONNECTING THE BATTERY
1. Position the battery (1) in its
compartment under the seat;
2. Connect the battery connector (2) to
the machine connector (3);
3. Recharge the battery by following the
instructions in the Manual(
☛
6.2.3).
Never start the engine until the battery is fully charged!
Avoid short circuiting!
Beware of fire, explosion or burns.
Do not disassemble the battery or heat it up above 55°C, and do not dispose of it in a fire!
Note that the battery electrolyte is a solution of sulphuric acid; when it comes into contact
with skin wash it with large amounts of water. In case of eye contact seek medical attention.
Store the battery out of reach of children!
Follow the battery manufacturer's instructions regarding safe
handling and disposal.
3.6 FITTING
THE GRASS-CATCHER
Identify the screws to be used by following the drawing that shows them in their actual Size
Fit the two tie rods (1) and fasten them by using the
screws (2)
1
2
3
4
1
2
3
1
2