LevelOne GEL-5261, User Manual

Page: 122 / 570

Chapter 4
| Interface Configuration
Trunk Configuration
– 122 –
■
If an LAG already exists with the maximum number of allowed port
members, and LACP is subsequently enabled on another port using a
higher priority than an existing member, the newly configured port will
replace an existing port member that has a lower priority.
Note: Configuring LACP settings for a port only applies to its administrative state,
not its operational state, and will only take effect the next time an aggregate link is
established with that port.
Note: Configuring the port partner sets the remote side of an aggregate link; i.e.,
the ports on the attached device. The command attributes have the same meaning
as those used for the port actor.
Web Interface
To configure the admin key for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Aggregator from the Step list.
3.
Set the Admin Key and timeout mode for the required LACP group.
4.
Click Apply.
Figure 49: Configuring the LACP Aggregator Admin Key
To enable LACP for a port:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Aggregation Port from the Step list.
3.
Select Configure from the Action list.
4.
Click General.
5.
Enable LACP on the required ports.