Reflectors
Leuze electronic GmbH + Co. KG
AMS 307
i
31
TNT
35/7-2
4V
6.3
Selecting reflector size
Depending on the system design, the reflector can be mounted so that it moves with the
vehicle or it can be mounted at a fixed location.
Attention!
The reflector sizes shown below are a recommendation from Leuze for on-vehicle mounting
of the
AMS 307
i
. For stationary mounting of the
AMS 307
i
, a smaller reflector is generally
sufficient for all measurement distances. For this reason, two smaller reflector sizes are avai
-
lable in the self-adhesive variant "-S".
During system planning and design, always check whether mechanical travel tolerances
require the use of a reflector larger than that which is recommended. This applies, in partic
-
ular, when the laser measurement system is mounted on a vehicle. During travel, the laser
beam must reach the reflector unobstructed. For on-vehicle mounting of the
AMS 307
i
, the
reflector size must accommodate any travel tolerances that may arise and the associated
"wandering" of the light spot on the reflector.
Overview of reflector types
Recommended reflector size
Selected AMS 307
i
(operating range in m)
Recommended
reflector size
(H x W)
Type designation
…-S = self-adhesive
…-M = Carrier plate
…-H = heating
Part no.
AMS 307
i
40 (max. 40m)
200 x 200mm
REF 4-A-150x150
1)
Reflective tape 200x200-S
Reflective tape 200x200-M
Reflective tape 200x200-H
REF 4-A-300x300
1)
1) For landside mounting
50141015
50104361
50104364
50115020
50141014
AMS 307
i
120 (max. 120m)
500x500mm Reflective tape 500x500-S
Reflective tape 500x500-M
Reflective tape 500x500-H
50104362
50104365
50115021
