Display and control panel AMS 335i
Leuze electronic
AMS 335
i
49
TNT
35/7-2
4
V
Notice!
If a password was stored, parameter enabling is not possible until this password is entered,
see "Password for parameter enabling" below.
Password for parameter enabling
Parameter entry on the AMS 335
i
can be protected with a password. With the AMS 335
i
,
the password is defined via the EDS file (class 100, instance 1). Thus, the password cannot
be changed by means of display entry.
To activate parameter enabling via the display (e.g., for changing an address), the password
defined in the EDS file must be entered. If parameter enabling has been activated after
successfully entering the password, parameters can temporarily be changed via the display.
After deactivating the parameter enable, all changes made to the display are overwritten by
the start-up sequence that may be stored in the control (see above). If a new password has
been assigned, this, too, is overwritten by the password defined in the EDS file.
Notice!
The
master password 2301
can enable the AMS 335
i
at any time.
