Lay out the two (2) Side Tubes [
B
] and
four (4) Cross Tubes [
A
] as shown
[Figure 1].
NOTE:
Each Cross Tube [
A
] end should
align with the holes located on the sides
of the Side Tubes [
B
].
NOTE:
The Pull Latches located along
the Side Tubes [
B
] should be parallel
with the bent ends of the steel pulls
facing the interior of the assembly.
Insert one (1) Pin Nut [
C
] at each end
of Cross Tubes [
A
] through the holes
located on the side of the tube as shown
[Figure 2].
NOTE:
The “slot end” illustrates the Pin
Nuts’ [
C
] internal thread direction [Figure
3].
NOTE:
The “notched end” of the Pin Nut
should lock into the edge of the Cross
Tube [
A
] hole as shown [Figure 4].
Secure the Side Tubes [
B
] to the Cross
Tubes [
A
] by threading one (1) M6 x
65 Button Head Bolt [
D
] with a M6 Flat
Washer [
E
] through the Side Tubes and
into each Pin Nut [Figure 4].
Lay the Transition Flap [
F
] onto the end of the ramp assembly aligning the
mounting holes [Figure 5].
NOTE:
The Transition Flap [
F
] should be placed on the Cross Tube [
A
]
located furthest away from the Side Tubes [
A
] Pull Latches with the
Transition Flap pointing away from the assembly.
NOTE:
Installation of the Transition Flap [
F
] is optional, and can be
removed for fold flat storage fit on the GearCage carrier floor of Let’s Go
Aero 4ft models.
PAGE 3 OF 9
STEP 1
STEP 2
STEP 3
[Figure 1]
[Figure 2]
[Figure 4]
C
NOTCH
END
SLOT
END
[Figure 3]
[Figure 5]
TOOL(S): 4mm ALLEN WRENCH & FLAT HEAD SCREWDRIVER
A
A
F
A
E
C
B
B
Pull Latches
C
D
B
A
B
Pull Latches
D
