PAGE 6 OF 9
STEP 8
Working from the bottom of the Ramp assembly, secure the Floor Panel using six (6) M6 x 16 Buttonhead Bolts [
P
], twelve
(12) M6 Washers [
S
], and six (6) M6 Nylock Nuts [
J
] as shown. [Figure 10]
S
J
S
[Figure 10]
TOOL(S): 4mm ALLEN WRENCH & 10mm SOCKET or WRENCH
STEP 9
Remove the End Rail and
associated hardware located on the
passenger side of the carrier. [See
your GearCage Manual for proper
procedure]. [Figure 11]
NOTE:
The existing Pin Nuts that
secure the GearCage Side Rail
to the End Rail will be used for
mounting the Ramp Latch Keepers
and should remain in place.
TOOL(S): 5/32 ALLEN WRENCH & FLAT HEAD SCREWDRIVER
End Rail
GearCage
Pin Nut
[Figure 11]
P
