Lenovo ThinkSystem SR635, Maintenance Manual

Page: 173 / 246

Figure 146. M.2 retainer adjustment
Step 1. Press both sides of the retainers.
Step 2. Move the retainer forward until it is in the large opening of the keyhole.
Step 3. Take the retainer out of the keyhole.
Step 4. Insert the retainer into the correct keyhole.
Step 5. Press both sides of the retainer.
Step 6. Slide the retainer backwards until it is seated in place.
Install the M.2 adapter and M.2 drive
Use this information to install the M.2 adapter and M.2 drive.
“
Read
the
installation
Guidelines” on
page 79
“
Power off
the server for
this task” on
page 11
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 82
Before installing the M.2 adapter and M.2 drive:
1. Touch the static-protective package that contains the new M.2 adapter and M.2 drive to any unpainted
surface on the outside of the server. Then, take the new M.2 adapter and M.2 drive out of the package
and place them on a static-protective surface.
2. Adjust the retainer on the M.2 adapter to accommodate the particular size of the M.2 drive you wish to
install. See “Adjust the retainer on the M.2 adapter” on page 162.
3. Locate the M.2 drive slot on the M.2 adapter.
Note:
For some M.2 adapters that support two identical M.2 drives, install the M.2 drive in slot 0 first.
Chapter 3
.
Hardware replacement procedures
163