Lenovo ThinkServer TS130 1098, Hardware Maintenance Manual

Page: 71 / 130

To reinstall the server cover and reconnect cables to your server, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws are
left inside your server. See “Internal components” on page 18 for the locations of various components in
your server.
2. If you have removed the front bezel, reinstall it. See “Removing and reinstalling the front bezel” on
page 26.
3. Make sure that the cables are routed correctly before reinstalling the server cover. Keep cables clear of
the hinges and sides of the server chassis to avoid interference with reinstalling the server cover.
4. Position the server cover on the chassis so that the rail guides on the bottom of the server cover engage
the rails on the chassis. Then, slide the cover to the front of the server until it snaps into position.
Figure 44. Reinstalling the server cover
5. Install the screws to secure the server cover.
6. Lock the server cover if you have a server cover lock. See “Integrated cable lock” on page 61 or
“Padlock” on page 61.
7. Reconnect the external cables and power cords to the server. See “Front view” on page 13 and “Rear
view” on page 14.
8. Depending on the parts you installed or replaced, you might need to confirm the updated information in
the Setup Utility program. Refer to Chapter 6 “Configuring the server” on page 63.
Note: In most areas of the world, Lenovo requires the return of the defective Customer Replaceable Unit
(CRU). Information about this will come with the CRU or will come a few days after the CRU arrives.
Connecting the cables
Attention: To prevent damage to equipment, connect the power cords after completing the parts
replacement.
Chapter 5
.
Installing, removing, or replacing hardware
59