Lenovo ThinkServer TS130 1098, Hardware Maintenance Manual

Page: 103 / 130

POST error code POST error message Description/Action
0197
System security - Unauthorized security
data change detected Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
0190
System security - Invalid security change
requested Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
0199
System security - Security password retry
count exceeded Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
EasyStartup problems
The following table describes the EasyStartup problems and suggested actions to correct detected problems.
Table 27. ThinkServer EasyStartup DVD
Follow the suggested actions in the order in which they are listed in the Action column until the problem
is resolved.
Symptom Action
The ThinkServer
EasyStartup DVD will
not start.
• Make sure that the server supports the EasyStartup program and has a startable
(bootable) DVD drive.
• If the startup (boot) sequence settings have been changed, make sure that the DVD drive
is first in the startup sequence.
• If more than one DVD drive is installed, make sure that only one DVD drive is set as the
primary drive. Start the EasyStartup DVD from the primary DVD drive.
The operating system
installation program
continuously loops. Make more space available on the hard disk drive.
The EasyStartup
program will not start
the operating system
medium. Make sure that the operating system medium is supported by the EasyStartup program.
See the
EasyStartup User Guide for a list of supported operating system versions. The
EasyStartup User Guide and compatibility notes are available through the EasyStartup
program.
Miscellaneous error messages
Symptom FRU/Action
Changing display colors Display/Monitor
Computer will not turn off. See “Hard disk drive boot
error” on page 88. 1. Power switch
2. System board
3. Riser card, if installed.
Computer will not RPL from server 1. Ensure that Network is set as the first device or it is
after CD/DVD in the startup sequence.
2. Ensure that the network adapter is enabled for RPL.
3. Network adapter (Advise the network administrator
of new MAC address)
Chapter 7
.
Troubleshooting and diagnostics
91