Lenovo 7360D6U - THINKCENTRE M58 7360, Hardware Maintenance Manual

Page: 116 / 566

Replacing a memory module
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace a memory module. Your computer can support
a maximum of four memory modules.
To replace a memory module:
1. Open the computer cover. See “Opening the computer cover” on page 103.
2. Pivot the drive bay assembly upward to gain access to the system board. See “Accessing the system
board components and drives” on page 104.
3. Locate the memory slots. See “Locating parts on the system board” on page 106.
4. Remove the memory module being replaced by opening the retaining clips as shown.
Figure 45. Removing the memory module
5. Position the replacement memory module over the memory slot. Make sure the notch 1 on the memory
module aligns correctly with the slot key 2 on the system board. Push the memory module straight
down into the slot until the retaining clips close.
108
ThinkCentre Hardware Maintenance Manual