Note:
You must remove the hard disk drive to gain access to the Clear CMOS
/Recovery jumper. See “Replacing the hard disk drive” on page 22.
4.
Locate the Clear CMOS /Recovery jumper on the system board. See “Locating
parts on the system board” on page 11.
5.
Move the jumper from the standard position (pin 1 and pin 2) to the
maintenance position (pin 2 and pin 3).
6.
Reinstall the hard disk drive.
7.
Lower the optical drive bay assembly and reconnect any cables that were
disconnected.
8.
Close the computer cover and connect the power cord. See “Completing the
parts replacement” on page 37.
9.
Turn on the computer and leave it on for approximately 10 seconds. Then,
turn off the computer by holding the power switch for approximately five
seconds.
10.
Repeat step 1 through step 3.
11.
Move the Clear CMOS /Recovery jumper back to the standard position (pin 1
and pin 2).
12.
Reinstall the hard disk drive.
13.
Lower the optical drive bay assembly and reconnect any cables that were
disconnected.
14.
Close the computer cover and connect the power cord. See “Completing the
parts replacement” on page 37.
40
User Guide
Summary of Contents for 3245A8U
