3
4
5
6
Figure 36. Installing the screw to secure the bracket on the bottom of the optical drive bay
12. Connect one end of the signal cable to the bottom of the new solid-state drive and the other end to
an available SATA connector on the system board. See “Locating parts on the system board” on
page 13. Then, locate an available four-wire power connector and connect it to the bottom of the
new solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 76.
Replacing the power supply assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” on page v.
This section provides instructions on how to replace the power supply assembly.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
54
ThinkCentre E73 User Guide
Summary of Contents for 10AU
