6. Disconnect the signal cable and the power cable from the hard disk drive to completely remove the hard
disk drive from the chassis.
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See “Locating parts on the system board” on page 13.
Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive.
Figure 22. Connecting a SATA hard disk drive
8. Position the new hard disk drive into the hard disk drive bay and align the screw holes in the new hard
disk drive with the corresponding holes in the drive bay. Then, install the four screws to secure the
new hard disk drive in place.
3
4
5
6
Figure 23. Installing the hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 76.
Replacing the optical drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” on page v.
Chapter 5
.
Installing or replacing hardware
45
Summary of Contents for 10AU
