Lennox SEREFINA CI1500DVF series, Installation Instructions Manual

Page: 15 / 20

15
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
4 . Place the center log piece over the cor-
responding pins next to the front left log as
shown in
Figure 23 .
Center
Log
Piece
Figure 23
Center
Top Twig
Right
Front Twig
Embers
Figure 28
DO NOT PLACE EMBERS ON TOP OF THE
BURNER SLOTS.
7. Install the center top twig onto the cor-
responding pin on the rear log and align it
with the indentation on front left log as shown
in
Figure 26 .
8. Install the front right twig onto the cor-
responding pin on the right front log. Align
the twig with the indentation on the front right
log as shown in
Figure 27 .
9. Place the glowing embers on the burner
as shown in Figures 28 and 29 .
One package of ember material has been
included with this log set You will not need
to use the entire bag.
IMPORTANT: The quantity and placement of the
ember material can affect stove performance
therefore it is very important that it be placed
as shown in
Figure
s 28 and 29
.
a. Unpackage and divide the fi ne ember material
(mineral wool) into dime-sized fl uffy pieces.
b. Distribute the pieces over the top of the
front burner ports avoiding covering the slots
(see
Figure 29 ) and fi lling the area in front of
the forward logs.
Figure 26
Figure 27
Figure 29
VERIFY THAT THE GAS LINE HAS BEEN
PURGED OF AIR (SEE STEP 10).
Figure 25
Left Top
Twig
Step 12. RE-INSTALL FRONT GLASS
ENCLOSURE PANEL
(Reverse instructions on Step 4)
Retrieve the front glass enclosure panel.
Visually inspect the gasket on the backside
of the frame. Gasket surface must be clean,
free of irregularities and seated fi rmly.
With the stove top off, position the glass front
enclosure panel into the front opening with
the gasket facing the relief door (reference
Figures 8 and 9 ) . Let the bottom of the door
frame gently slide down, then hook the top
fl ange of the glass frame over the top of the
fi rebox frame.
Right Front Log
Figure 24
5. Install the right front log onto the cor-
responding burner pin and sub-fl oor right
tab as shown in
Figure 24 .
6. Install the left top twig onto the correspond-
ing pin on the rear log and align it with the
indentation on the front left log as shown in
Figure 25.