9
Use the following procedure for installation of the Mag-Mount where existing
thermostat wiring does not exist:
1.
Unpack the HD Display and Mag-Mount (wall base).
2.
Determine the best location to install Mag-Mount. Ideal location should be
located away from outside wall, direct sunlight or discharge air vents.
3.
Cut or drill a small hole for thermostat wiring.
3/8” (10 mm)
Diameter Hole
4.
Pull about three inches of thermostat wire through the opening and remove the
outer thermostat wire jacket.
Seal wire hole in wall to prevent
cold or hot air from affecting temperature
sensor in display
IMPORTANT
Seal wire hole in wall to prevent cold or hot air from affecting temperature sensor
in HD Display.
5.
Strip 1/4” (7 mm) insulation from end of each wire.
1/4”
6.
Use a level to align either the mag-mount or wall plate on wall horizontally.
7.
Remove cover from mag-mount by inserting a flat-head screwdriver into the
slot on each side of the mag-mount. Give it a gentle twist to separate the two
sections.
Slot
Slot
8.
Use mag-mount as a template to mark the desired mounting hole locations on
the wall.
Use either the Mag-Mount or wall
plate as a template to mark the
desired mounting hole locations
on the wall.
9.
Drill 3/16” (5 mm) holes at marked locations on the wall for anchors. Then insert
wall anchors into holes until flush with the wall.
Drill Holes
Insert in hole until flush with wall
10.
Secure mag-mount to wall or through wall-plate to wall with provided #6 x 1.25”
pan head screws (4).
11.
Connect thermostat wiring and reinstall access cover.
Summary of Contents for iComfort E30
Page 47: ...47 ...
