Operation
63
The implement's working depth can be ad-
justed from 3 cm to 10 cm.
It is adjusted using guide pins.
Slightly lift the implement above the trac-
tor's three-point linkage.
Release the lower guide pins (1) by re-
moving the linch pins.
Insert the lower guide pin (1) in a hole in
the adjusting plates (2) corresponding to
the desired working depth:
Hole 1 => Lowest working depth
Hole 12 => Highest working depth
Insert the implement in the ground.
When the working depth is reached, the
load on the upper guide pins (3) is re-
lieved.
Insert the upper guide pins (3) directly
above the carrier (4) so that the weight
of the rollers provides additional support
for the implement's intake behaviour.
When the working sections are raised the
clearance between the rollers and the
ground is increased.
Secure the guide pins by inserting the
linch pins.
4
3
