LEM DX 26 PLUS, Manual

Page: 14 / 64

14
First Setup
At this point, the first custom setup can be prepared.
The following is only a description of setup procedure.
The detailed specifications of each parameter are shown in the respective paragraphs of the manual.
☞
Firstly, set the following parameters in the order shown:
Output Pol. Polarity of the outputs
Xover Crossover frequencies (separation of the speaker channels)
Output Delay Alignment of the speaker enclosure components
Output Gain Levels of the outputs
N.B.: the regulation of the DX 26’s parameters is closely linked to the characteristics of the sound system’s components.
So if you’re not experts, refer to the documentation and technical specifications of your power amplifiers, loudspeaker
enclosures, monitors, etc. This will enable you to work faster and safely.
☞
Disable the MUTE function on the outputs you intend using and listen the sound, carry out instrumental
checks (if you have the necessary equipment) and any corrections required.
☞
Then, if necessary, adjust the values of the following functions:
Output EQ Output equalizers
Output Comp/Limit Output compressor/limiters
N.B.: in this first phase of setting up your sound system, the adjustment of these functions (which are very useful, if
not indispensable during installation) can wait. Remember however that adjusting the equalizers also affects the signal
level. So if considerable equalization changes are made, remember to check and if necessary adjust the output levels
too.
Getting Started