Leister Technologies AG
Operating Manual
Welding Machine SEAMTEK 36
Revision: A
QM
Page
7 / 62
Created
04.04.2014 TEX
Released
Modified
7
Warning
: Symbols, like this one, alert you to practices that may cause damage to the machine.
Opening the device is
extremely dangerous,
since live parts and
connections are exposed. Remove the plug from the socket before
opening the device.
Danger of fire and explosion
if the extrusion welder is used
incorrectly (e.g. overheating of material), particularly near
combustible materials and explosive gases.
Danger – can cause burns !
Do not touch bare metal parts and
emerging material while hot. Allow the device to cool. Do not direct
stream of hot air or emerging material towards people or animals.
Connect device to
power socket with protective earth conductor.
Any break in the protective earth conductor inside or outside the
device is dangerous!
Only use extension cables with a protective earth conductor!
Caution
:
The
nominal voltage
indicated on the device must correspond to the
mains voltage. If power failure occurs, the main switch and drive
must be switched off (release locking device).
When using the device on building sites, a
residual current circuit
breaker
is
essential for the safety
of persons there.
The device must
not be left unattended
when in use. Heat can reach
combustible materials which are out of sight.
The device may only be used by
trained personnel
or under their
supervision. Children may not use the device under any
circumstances.
Keep away from wet and damp areas.
While
working on the open system
avoid wearing garments such as
shawls, scarves and ties. Long hair must be tied or protected by
headgear.
