20
Instruction manual V 1.6 – 10/2009
4.
Startup
22
25
24
21
23
The voltage selector is located above the main
power switch, on the left-rear side of the instru-
ment (
Fig.
7). The voltage setting is displayed in
the viewing window (
22
).
•
Insert a small screwdriver into the cutout
(
25
) and carefully pry out the insert.
•
Remove the voltage selector housing (
21
)
together with the fuses (
23
). Remove the
voltage selector block (
24
) (white) and insert
it again such that the correct local voltage is
displayed in the viewing window (
22
).
•
Reinsert the voltage selector housing with
the block and fuses and push it in until it
engages (audible click).
21
26
27
Fig. 12
Checking the voltage
(continued)
Fig. 13
Connecting the control panel
The connecting cable (
15
) of the control panel is
fixed to the microtome. It may not be discon-
nected.
•
Insert the plug (
14
) of the connecting cable
(
15
) into the connecting jack (
16
) on the rear
of the control panel.
•
To fasten the plug, tighten the two screws
(
17
).
15
16
14
17
