iCON robot 60/iCON builder 60, Operation
32
Connect to
computer via USB
cable step-by-step
6.
Check
Install the software automatically (Recommended)
.
Next>
. The
software for
Remote NDIS based LGS TS Device
will be installed on your
computer
7.
Finish
.
8.
The
Found New Hardware Wizard
starts up automatically a second time.
9.
Check
Yes, this time only
.
Next>
.
10.
Check
Install the software automatically (Recommended)
.
Next>
. The
software for
LGS TS USB Device
will be installed on your computer.
11.
Finish
.
12.
For PCs with Windows Vista or Windows 7/Windows 8 operating system:
Windows Mobile Device Center starts up automatically. If it does not start
automatically, start Windows Mobile Device Center.
Step
Description
Step
Description
1.
Start the PC.
2.
Plug the GEV223 cable into iCON robot 60/iCON builder 60 instrument.
3.
Turn on the iCON robot 60/iCON builder 60 instrument.
4.
Plug the GEV223 cable into the USB port of the computer.
For PCs with Windows Vista or Windows 7/Windows 8 operating system:
Windows Mobile Device Center starts up automatically. If it does not start
automatically, start Windows Mobile Device Center.
If Windows Mobile Device Center is not installed, run the Mobile device
Center installation program.
5.
Press
Connect without setting up your device
.
The folders on the iCON robot 60/iCON builder 60 instrument are displayed
under
File Management
. Press
Browse the content of your device
. The
folders of the data storage device can be found in either of the following
folders:
• Leica Geosystems\iCON\res\data
•
SD Card
•
USB memory device
006313_001
3
2
4
