74
8. Operation
!
8. Operation
8.1 Switching On
When using a gas discharge lamp, the ebq 100
external supply unit must be turned on separate-
ly (104.1).
Switch on the power of the CTR6000 electronics
box at the On/Off switch (105.1). The signal lamp
(105.2) is lit green when the unit is ready.
Note:
If a PC is connected, switch on
the electronics
box first
, and
then the computer
.
All motorized microscope components will then
run through an initialization phase.
Note:
In the case of faulty initialization ("Init Error"
message on LeicaScreen), see Troubleshooting
chapter,
→
p. 91.
All of the user's previous settings are restored
during the initialization.
Caution:
The focal position and the lower stop are
also retained from one session to the next
when power is switched off.
Fig. 104
Front panel of ebq 100 supply unit
1
Power switch
2
Lamp status
1
2
Fig. 105
Front side
Leica CTR6000
1
On/Off switch
2
Signal lamp
1
2