Leica CM1510 – Cryostat
29
11.3 Replacement of the lamp
Turn the instrument off with the mains switch
and pull the mains plug before placing the
lamp!
•
Slightly lift the closed sliding window
(1)
holding it
by the grip
(2)
and pull it out to the front.
If the lamp is broken it must be replaced by
the technical service, as the replacement in-
volves a high risk of injury!
Removal of the lamp
•
The lamp
(3)
is mounted behind the cover
(4)
and
therefore not visible.
•
Touch the lamp for better orientation.
•
Slightly
tilt the fluorescent tube down to the left and
pull it out of the clip
(5)
.
•
Hold the lamp with both hands and pull it
to the left
out of the lamp holder
(6)
.
Do not use lamp type other than specified by
the manufacturer!
Assembly of the new lamp
Lamp type:
(230 V/50 Hz)
OSRAM DULUX S - 11 W
(115 V/60 Hz)
OSRAM DULUX S - 13 W
•
Hold the lamp in the correct mounting position as
shown
(Fig. 29.3)
and push it to the right until it en-
gages in the lamp holder.
•
Lightly push the fluorescent tube upward to engage
in the clip.
•
Replace the sliding window.
•
Reconnect the instrument to mains and turn it on.
11.
Maintenance
1
2
5
4
3
6
Fig. 29.1
Fig. 29.2
Fig. 29.3
Summary of Contents for CM1510
Page 2: ......
