OMEGA
Installation Manual
Edition Dec. 2004
Omega
platform lift
page 13 of 24
Mounting the carriage
When the tube system is securely in place, begin
mounting the carriage. Complete the following steps:
•
Bring the carriage to the bottom of the tube
system and unwrap it.
•
Remove the shoulder bolts for the conical
rollers and the rope liners.
•
Carefully lift the carriage into position, guiding
the upper carriage rollers onto the upper tube. Ensure that the rope levers fit between the
bosses of the upper carriage. Be careful not to scratch the paint on the tubes.
Note:
The carriage weighs about 90 kg, so two people should install it to ensure safety
and avoid damage.
•
Screw the carriage on the rope levers of the tension
and support rope.
•
Install the conical rollers on the lower tube. Put some
grease on the area of the shoulder bolt on which the
conical rollers will rotate.
•
This diagram on the right side shows the carriage
arrangement on the lower tube.
•
Open the upper front side of the carriage by using a
hexagon socket wrench.
Note:
Remove the four-pole plug from the socket and
put the special plug for mounting only (delivered from
Lehner-Lifttechnik
with the first plant) into the socket.
Now you have bridged key switch and emergency
stop.
•
Open the lower front side of the carriage by using a
hexagon socket wrench.
Note:
Dismantle the connection between slider and
platform first!
Caution:
The barriers are without support now – they will
fall down – watch your head!
conical
rollers
