1. Make sure that the power has been turned off at the circuit breaker.
2. Connect wires to the OSR300S wire leads as shown in the wiring diagrams.
The ground wires must be
tightly fastened
or the unit will not operate
properly. If the metal junction box is grounded, it can be a suitable ground.
Attach a ground wire to the green terminal as shown.
3. Attach the sensor to the wall box by inserting screws into the two wide holes
on the top and bottom of the attached metal bracket. Match them up with the
holes in the wall box and tighten.
4. Turn the circuit breaker on. Wait one minute, then push the Auto ON/OFF
switch for each load and the lights will turn on. There is a delay due to initial
power-up of the sensor that only occurs during installation.
Screw Terminal
Push–In
INSTALLATION
Neutral
Ground
Blue
Line
Black
Secondary
Load
Brown
Primary
Load
Red
White
Blue
Ground
Primary
Load
Secondary
Load
Neutral
White
Red
Brown
Line 2
Line 1
Black
Neutral
White
Bi-Level Wiring
Dual Circuit Wiring
CAUTION
TURN THE POWER OFF AT THE
CIRCUIT BREAKER BEFORE
INSTALLING THE SENSOR OR
WORKING ON THE LOAD.
Insert or wrap ground wire as shown.
Tighten screw in the clockwise direction.
WARNING
THE GROUND MUST BE TIGHTLY
SECURED OR THE SENSOR
WILL NOT WORK.
!
!
#12 – #14 AWG
Cu Wire Only
Strip Gauge
Visit our website at www.passandseymour.com
