12
Player Portfolio Audio System
| Product Manual
0.
The screen displays
Setup Complete!
(See Figure 20). Select
Finish
and the app jumps to the HOME screen.
a.
Remove the Ethernet connection from the player.
NOTE:
A software update may be necessary for any Nuvo components. If prompted with an update, select
Continue
to update the firmware.
ADDING A COMPONENT TO AN EXISTING SYSTEM
See “Add a Nuvo Component” on page 16.
CHANGING AN EXISTING ETHERNET CONNECTED COMPONENT TO WIRELESS
IMPORTANT:
This section only applies to players that are capable of being wireless. Rackmount players do not have a wireless option.
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
To change a wireless-capable component from wired operation to wireless operation, perform the following steps:
1.
Navigate to the SETTINGS menu (See Figure 21). Refer to “The Settings Menu” on page 16 for more detail.
2.
Choose the zone name for update (See Figure 22).
3.
Select the
Wireless
option (See Figure 23).
4.
Select the
Network
option (See Figure 24).
5.
Select the same network as where the Nuvo Player app is connected (See Figure 25), then enter the password for
the network. Select
Join
6.
If the correct password is entered, “Joining” displays on the screen. When successfully connected, the screen
displays a successful connection message (See Figure 18).
NOTE:
If an incorrect password is entered,
Connection Failed
displays and you need to enter the password again.
7.
The screen shows the connection in the wireless settings (See Figure 19). Press
Done.