Installation Instructions
PRSU
7
Attaching Display to Stand
WARNING:
EXCEEDING MAXIMUM WEIGHT CAPACITY
MAY LEAD TO SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer’s responsibility
to ensure the total amount of weight placed on the stand does
not exceed 200 lbs (90.72 kg).
CAUTION:
Before attaching display to the stand ensure the
stand is on level surface.
1.
Open both flags on top mounting holes in faceplate. (See
Figure 8)
2.
While supporting both sides of display, align four mounting
buttons on PSBU with four mounting holes in faceplate.
(See Figure 8)
Figure 8
CAUTION:
THE DISPLAY MAY WEIGH IN EXCESS OF 40
LBS! Always use two people and proper lifting techniques
when installing, removing or positioning display on stand.
3.
Lower display into place ensuring recessed area of
mounting buttons are properly seated in lower area of
mounting holes. (See Figure 9)
4.
Close flags to secure interface to mount. (See Figure 8)
Figure 9
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
STAND OR DISPLAY FALLING CAUSING SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT!
Ensure mounting buttons are completely engaged in
mounting holes.
NOTE:
Holes are provided in the faceplate for use with a
padlock or similar locking device, if desired. (See
Figure 9)
CAUTION:
ALWAYS remove the display BEFORE
adjusting the height of the stand.
OPEN
CLOSED
1
2
4
2
3
Padlock may be
used through
latch hole after
flag has been
closed.
