Legato NetWorker, Release 7.0
Disaster Recovery Guide
5
Prerequisites
96
Task 1: Install the NetWorker Software
To install the NetWorker software:
1. Install the same version of NetWorker software into its original location.
For installation instructions, refer to the Legato NetWorker Installation
Guide, NetWare Version.
•
If you want to upgrade the NetWorker server, first recover the server
to its original state, and then perform the upgrade.
•
You do not need to reload the license enablers if the NetWorker
configuration files still exist. By default, the configuration files are
located in the SYS:NSR\RES directory.
2. Install any NetWorker patches that were installed prior to the disaster.
Task 2: Configure NetWorker Device and Client Resource
To configure the device and client resource:
1. Configure the Device resource:
Note:
If you are recovering data using an autochanger, enter [F4] to verify that
the autochanger correctly appears in the Autochanger window.
2. Configure the Client resource associated with the server.
Set the browse and retention policies to a decade. The browse policy is one
quarter (four months) by default. This enables you to recover all of the
server’s records.
Important:
If you do not reset the browse and retention policies, all of the
server’s records will be recovered. However, any records that are more than
one quarter (four months) old will be discarded, because the browse policy is
one quarter by default.
Summary of Contents for Legato Networker
