Lega DV4 D.B., Instruction Manual

Page: 11 / 27

LEGA LEGA LEGA LEGA
srl srl srl srl
C C C Costruzioni ostruzioni ostruzioni ostruzioni A A A Apistiche pistiche pistiche pistiche – – – – via Maestri del Lavoro 23 via Maestri del Lavoro 23 via Maestri del Lavoro 23 via Maestri del Lavoro 23 – – – – 48018 Faenza 48018 Faenza 48018 Faenza 48018 Faenza
www.legaitaly.com www.legaitaly.com www.legaitaly.com www.legaitaly.com ---- Tel 054626834 Tel 054626834 Tel 054626834 Tel 054626834 – – – – Fax 054628279 Fax 054628279 Fax 054628279 Fax 054628279 – – – – P.iva 00043230390 P.iva 00043230390 P.iva 00043230390 P.iva 00043230390
11 / 27
Place the frames on the (stationary) chain perpendicularly to the chain
(fig. 3) and cause the chain to run towards the machine inlet so that
9/10 frames can be added.
Press the ‘START CYCLE’ key (fig. 1 item A).
It is also possible to load the frames when the uncapping machine has
been started, i.e. when the chain is moving, in a continuous manner.
If a frame gets stuck, turn the main switch (fig. 1 item C) to the left.
Hold down the "START CYCLE" button so that the frame moves back
and then replace the frame correctly.
To stop the uncapping machine, turn the main switch (fig. 1 item C) to its 0 position.
In case of danger, hit the emergency button ( In case of danger, hit the emergency button ( In case of danger, hit the emergency button ( In case of danger, hit the emergency button (
fig. 1 item
fig. 1 item fig. 1 item
fig. 1 item
D). D). D). D).
The emergency stop shall prevail over all other functions and operations. The emergency stop shall prevail over all other functions and operations. The emergency stop shall prevail over all other functions and operations. The emergency stop shall prevail over all other functions and operations.
2.1
2.1 2.1 2.1 INSTRUCTIONS FOR THERMOREGULATOR USE INSTRUCTIONS FOR THERMOREGULATOR USE INSTRUCTIONS FOR THERMOREGULATOR USE INSTRUCTIONS FOR THERMOREGULATOR USE
The thermoregulator located on the control panel has four keys and a display unit.
After connecting the DV4 machine to line power and waiting a few seconds, check the display unit for the
knife temperature reading.
Press the SET button to display the maximum selected temperature setting.
To change this temperature setting, press the SET (C) control then press the button with the arrow pointing up
(A) to increase the temperature degree value or the button with the arrow pointing down (B) to decrease it.
3.0
3.0 3.0
3.0 MAINTENANCE
MAINTENANCE MAINTENANCE
MAINTENANCE
CAUTION! CAUTION! CAUTION! CAUTION! MAINTENANCE OPERATIONS SHOULD BE CARRIED OUT AFTER STOPPING THE MACHINE AND
DISCONNECTING ELECTRIC POWER.
No special maintenance is required.
The machine should be washed with warm water and mild detergents of the type commercially available for
stainless steel, if necessary.Do not in any case clean the machine with steam jets.
CAUTION!
CAUTION! CAUTION! CAUTION!
1) BE EXTREMELY CAREFUL WHEN HANDLING THE KNIFE BLADES, E.G. DURING WASHING
2) DO NOT DIRECT WATER JETS TOWARDS ELECTRICAL PARTS.
FIG. 3 Frame position
A A A A
B B B B
C C C C