removing mode.
2.
Short press Z-button triple.
3.
The LED keep blink to the end of remove exclusion, If
the remove for exclusion is successful, The LED will
keep slow flash, Otherwise, LED will be in power
indication mode.
Press more than
5seconds
Reset Smart Plug to factory Default:
LED in 5 seconds to
accelerate
flash,
The
reset
successful
will
send“Device_Reset_Locally” to the main controller and
exclude from the Z-Wave network, this procedure will reset
Smart Plug to factory default.
5 Note for special command
5.1 Association Command
1
,
The Smart Plug supports only one association group.
Grouping
Identifier
Max
Nodes
Send Commands
Group 1
0x05
1. When the state of Smart Plug (turn on or off the load)
is changed:
1.Set Configuration parameter 0x03 to 0:Do not send
Basic Report