LeeBoy 8510E, Operation, Service And Parts Manual

Page: 93 / 444

55
LeeBoy Model 8510E Conveyor Paver 5-3
Maintenance
Table 5-1. Periodic Maintenance Schedule
SYSTEM ITEM
Every
10
Hours
Daily
Every
50
Hours
Weekly
Every 100 Hours
Monthly
Every 250 Hours
Quarterly
Every
500
Hours
Semi-Annually
Every 1000
Hours Annually
Paver Lubricate paver. X
Engine
Check oil level. X
Check coolant level. X
Replace coolant. X
Check air filters. Clean if needed. X
Change air filters. X
Replace fuel filter. X
Change oil and oil filter. (Initial 50 Hours) X
Adjust main engine belt. X
Replace main engine belt. X
Hydraulic
Check hydraulic oil level. X
Change hydraulic oil. X
Change hydraulic filter. X
Check torque hub oil. X
Change torque hub oil. X
Drain hydraulic tank. Replace strainer. X
Mechanical
Adjust conveyor drive chains. X
Adjust conveyor flight chains. X
Adjust auger chains. X
Adjust screed extension top guide. X
Engine Operator’s Manual accompanying your paver for
more detailed engine service information.
When performing any routine maintenance, always
include the previous routine maintenance hours in the
higher hourly schedule.
NOTE: For convenience there is an oil drain hose
located inside of the right-hand door on the
paver.
Changing oil and cleaning the paver
should only be done in a designated area where
the oil and chemicals can be contained. These by-
products should be discarded in accordance with
environmental regulations.
Maintenance Schedule
Before performing any maintenance procedures on the
LeeBoy Model 8510E Conveyor Paver, review the safety
information in Section 1 .
Always use the appropriate and
correct-sized tools for the task at hand to prevent
damage or possible injury.
Always wear heat-resistant gloves
when handing hot components.
Following the maintenance schedules and procedures
will maintain the paver in top operating condition and
provide years of trouble-free operation. Refer to the