v.8.29.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
9
4. SET THE DRILL ANGLE
The Drill Jig has a level that enables drilling
holes into the rail at a consistent angle.
The drilling angle can be set at 10
°
intervals
from the vertical down position. Typical
installation angles are
- Standard beam (ST): 30
- Vertical down beam (AS/VA): 0
°
or 10
°
Follow the below instructions to adjust the
angle setter:
4.1 Loosen the two allen screws on the angle
setter with the supplied Allen key until you
can freely turn the angle setter (Fig. 4.1).
4.2 Turn the angle setter to the desired angle.
Note that each indicator mark represents
increments, or an offset, of 10
°.
4.3 Tighten the allen screws to lock the angle
setter in position.
Fig. 4.1 Loosen the two allen screws with the
Allen key to adjust the angle setter.
Above: The drill Jig’s level bubble should be
centered before the drilling to enable consistent
angle drilling at your set angle.
3
4
3
4
