v.8.29.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
16
DRILL JIG FLAT FACE SET UP
THE FLAT FACE SPACER
INSTALLING THE FLAT FACE SPACER
Square pipe/flat-faced rail applications
require a spacer fitted inside the Drill Jig.
The Drill Jig should come pre-fitted with
the required spacer, however be sure to
confirm it is installed, and to reinstall it as
described when removing/replacing the
cutters.
1. The Drill Jig cutter assembly is ready
for installing the spacer when there are
NO cutters and the cutter end is FULLY
EXTENDED (see Removing the Cutters
in step 3).
2. Simply insert the flat face spacer
(tapered end first, as pictured) into the
back of the Drill Jig’s cutter assembly.
3. Continue with installing the cutters.
Refer to Install/Replace the Cutters
(step 3 in this manual).
Above : the flat face spacer.
Flat face (square) rail applications require
the flat face spacer installed in the Drill Jig.
The flat face spacer is installed FIRST, followed by the cutter installation (see step 3).
Remember to fully extend the cutter end of the Drill Jig (as shown).
16mm cutter (with
cutter spacer)
flat face spacer
15mm cutter
1
2
3