
v.8.29.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
13
8. DRILL THE HOLE
8.1 Connect the drill’s 10mm nut driver
(female) to the matching (male) hex
drive on the Drill Jig (Fig. 8.1)
8.2 Engage the drill. DON NOT FORCE OR
PUSH THE DRILL. Use light pressure to
keep the socket engaged. STOP DRILLING
once the hex drive has fully receded into
the cutter assembly (Fig. 8.2).
8.3 Switch the drill to REVERSE, and
engage the drill to back out the cutters.
Ensure the hex drive is fully retracted from
the cutter assembly (Fig. 8.3).
NOTE! The resistance will vary during
the cut as the cutters penetrate the
metal. This is normal.
NOTE! When reversing, if the drill spins
and/or the hex driver does not retract,
offset the angle of the drill slightly 1-2”
while reversing. The drill and hex driver
should now reverse.
NOTE! Ensure your drill battery us
charged/changed as needed as this will
keep drill times effiecient and the Drill Jig
operating effectively.
Fig 8.1 Do NOT force/push the drill. Use light
pressure only to keep the socket engaged.
Fig 8.2 STOP drilling once the hex
drive has fully receded inside the Drill
Jig.
Fig 8.3 Set drill to reverse and back
out the cutters / hex drive until it is fully
retracted.
hex drive fully
RETRACTED
hex drive fully
RECEDED.
hex drive fully
RETRACTED
hex drive fully
RECEDED.