LBC LCR7W, Installation, Service And Parts Information

Page: 8 / 22

8
INSTALLATION (Part 1 of 5) 0
C A U T I O N
THIS APPLIANCE WEIGHS UP TO 600 LBS. FOR SAFE
HANDLING, INSTALLER SHOULD OBTAIN HELP AS
NEEDED OR EMPLOY APPROPRIATE MATERIAL-
HANDLING EQUIPMENT (SUCH AS A FORKLIFT, DOLLY
OR PALLET JACK) TO REMOVE THE UNIT FROM ITS
PACKING MATERIALS AND TO MOVE IT TO THE PLACE
OF INSTALLATION.
C A U T I O N
ANY STAND, COUNTER OR OTHER DEVICE ON WHICH
THIS APPLIANCE WILL BE LOCATED MUST BE DESIGNED
TO SUPPORT ITS WEIGHT
INSTALLATION OF THIS APPLIANCE MUST BE DONE
BY PERSONNEL QUALIFIED TO WORK WITH
ELECTRICITY. IMPROPER INSTALLATION CAN CAUSE
INJURY TO PERSONNEL AND/OR DAMAGE TO
EQUIPMENT.
W A R N I N G
C A U T I O N
ALL ELECTRICAL, MECHANICAL, GAS, VENTILATION
AND EXHAUST CONNECTIONS MUST MEET ALL
FEDERAL, STATE AND LOCAL CODES OR ORDINANCES.
N O T I C E
During the first few hours of operation, you may notice a
small amount of smoke and/or a faint odor coming from
the appliance. This is normal in a new equipment and
will disappear after a few hours of use.
Clearances
Minimum clearance from combustible construction: 0” from sides, 1” from back (single-door ovens only) or 6” from back
(double-door ovens) and 6” from top. This appliance may be installed on combustible surfaces. The installation location
must allow adequate clearances for servicing and for proper operation of loading door(s).
Stand
If the oven is supplied with a stand, check the level of the top surfaces. If the stand is not level, add shims (washers are
provided with the oven). Secure the oven to the stand with stainless steel hardware provided (16 each of the following:
10mm-1.2 x 20mm hex bolts, 10mm lock washers and 10mm plain washers.)
Drip Plates
Unpack and install the drip plates. No mounting hardware is required. The plates rest on the support pins located on each
side wall.