LazyMan LM210-28, Use And Care Manual

Page: 19 / 34

OPERATION OF YOUR GRILL
plate (for 28” size) or the FAR RIGHT Flavor
Enhancer plate (for the 40” size) and directly
to the burner. Turn the corresponding knob
to ‘HIGH’ to light the starter burner. Remove
the match or lighter and continue to light the
remaining burners using the flash tubes in
the rear of the grill.
USE EXTREME CAUTION WHEN LIGHTING
Use the lighting instructions found on the
previous pages to continue.
PRE-HEATING
As mentioned earlier, preheating your
grill is an important part of the grilling
process and will provide much more
consistent cooking results. It gives the
burners, the flavor enhancers, and the
g
rates time to properly and evenly warm
up.
Light your grill per the
LIGHTING INSTRUCT-
IONS
. Light all burners, and set the controls
to ‘HIGH’. Even if you are planning to use
only one or two burners, it is best to
preheat with all burners on. Close the
optional hood, if your grill is so equipped, to
begin pre-heating.
Pre-heat the grill for around 10 minutes
or around 350° as shown on the hood
thermometer. NEVER allow the
thermometer to exceed 450° indicating
that your grill is overheating.
Overheating can damage the grill hood and
grill components and is NOT covered by
warranty.
After pre-heating, turn off the burner(s)
that you do not plan to use.
WARNING
DO NOT leave the grill unattended during
the pre-heat process or ANY time while
the grill is in use.
DO NOT pre-heat the grill for more than
10 minutes as, damage caused by
overheating can result.
TYPES OF HEAT
The high powered burners used in your
LazyMan LM210 grill are capable of creating
a very large range of heat intensities. By
varying the number of burners used, the
temperature set, and the hood open/closed
positions (for hood models), a wide variety
of cooking possibilities exist. These
possibilities can lead to an endless list of
delicious recipes. The two primary types of
heat are ‘DIRECT HEAT’ AND ‘INDIRECT
HEAT’.
15