LS-CS-M0005-EN
LZS-003-HS Operation Manual – Dual Laser Version
Page 14
Version 1.11
Released: 03/12/2007
5
5
.
.
3
3
S
S
t
t
a
a
r
r
t
t
-
-
u
u
p
p
T
T
e
e
s
s
t
t
Once started, the LZS-003-HS will perform a start-up test to check the systems emergency
stop function and stopping performance of the press brake. Check the following prior to
commencing the start-up test:
•
Open the tools to a minimum opening of 50mm.
•
Check the transmitter and receiver are correctly aligned.
•
Check the laser to punch distance.
•
Check that the laser clear indicator LEDs are all on.
Note:
Refer to Section 4 or the Transmitter and Receiver Alignment Manual for detailed
information regarding alignment and laser to punch settings.
To commence the test, press the
down
pedal as indicated on the display. The beam will move
a short distance then stop.
Note:
After the start-up test is complete it may be necessary to restart the hydraulic pump.
Figure 5-3: Start-up test display
If the test completes successfully, the mute point will be set next. Press the
down
pedal to
continue, as shown in the following diagram. See Section 5.4 Setting the Mute Point.
Figure 5-4: Initial mute point setting
