9
8
PowerReclineXR
®
with Massage & Heat
Assembly Instructions
Hand
Wand
F
IGURE
1
F
IGURE
2
F
IGURE
3
F
IGURE
4
F
IGURE
5
F
IGURE
6
Plastic
Tie
Power
Supply Box
Massage
Connectors
Back
Bracket
Locking
Lever
at 90
Degree
Angle
Locked
Position
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
WARNING
3. Install the back.
•
Lay the back across the arms of the chair. Turn the locking levers, located on the brackets attached
to the back (one on each side), to a 90 degree angle (F
IGURE
5). Route the massage and heating pad
cables between the rear of the seat and the metal rear rail (F
IGURE
2). Do not allow the cables to
become pinched while installing the back.
•
Lift the back at a slight angle and align the brackets on the back with the brackets on the
body (F
IGURE
3).
•
Lower the back onto the body, making sure the back and body brackets are completely engaged.
-
To make sure the back is properly installed with both sets of back and body brackets
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position the brackets are not engaged (F
IGURE
4). Remove the back and repeat
the steps above.
-
If you are unable to install the back properly, contact your La-Z-Boy
®
dealer for assistance.
•
Lock the brackets by using a screwdriver to push down the locking levers (F
IGURE
5).
4. To access the connectors, gently roll the chair forward to rest on the arms and the top of the back.
The connectors are located at the back of the chair, under the rear seat.
5. Identify the electrical connectors (F
IGURE
6).
•
The rectangular red connectors are for the heating pad connection.
•
The rectangular brown and black connectors are for the massage connection.
•
The round black connector is for the power supply connection.
PowerReclineXR
®
with Massage & Heat
Assembly Instructions
NOTICE:
Do not plug in until instructed.
1. Carefully cut the plastic tie holding the power supply box and the hand wand to the
body bracket (F
IGURE
1).
2. Remove the hand wand from the bubble wrap, and lay the hand wand on the seat.
Heating Pad
Connectors
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
Massage & Heat Cables
Metal Rear Rail
Back Bracket
Body
Bracket
Power Supply
Connector
(Assembly Instructions Continued)
Power Supply
Connector
