13
12
PowerReclineXR
®
Rocking Loveseat Assembly Instructions
F
IGURE
1
Left Side (Sitting) Rocker Recliner
Front Attachment
Bracket
F
IGURE
3
F
IGURE
4
Console
Front Side
Mount “U”
Bracket
Front Attachment
Bracket (Console)
Front Attachment
Bracket (Left Side
Sitting Rocker
Recliner)
Rear
Side
Mount
Bracket
Threaded
Studs
F
IGURE
2
Right Side (Sitting) Rocker Recliner
8. The units must be disconnected before moving the loveseat. To disconnect the units, lift up the left front
corner of the right side (sitting) recliner approximately 3" to clear the front attachment bracket on the
console. Move the recliner to the side before returning it to the floor. Slide the right side (sitting) recliner
backward to disengage the back bracket on the console. Repeat these steps to disconnect the console
from the left side (sitting) recliner.
9. Proceed to the
Battery Backup Assembly Instructions
.
NOTICE:
– To reduce the risk of product damage:
• Do not move the units while connected together. The purpose of the bracket system is to
connect the units and prevent them from being separated while on the floor. The bracket
system does not provide adequate structural support for the movement of connected units.
Rear Bracket
Battery Backup Assembly Instructions
NOTICE:
The performance of the built-in battery backup cannot be guaranteed. If you require continuing
use during a power outage, you should purchase a separate battery backup system. Contact
your La-Z-Boy
®
dealer for more information.
To reduce battery consumption, the massage and heat features are blocked and unavailable
when the battery backup is in use. Additionally, the operating speed is reduced to decrease
energy consumption.
Always maintain constant even pressure on the button when operating on battery backup to
reduce the energy consumption.
The battery backup is located in the power transformer and uses two good quality, name brand
9-volt alkaline batteries (not included).
1. Unplug the 120 volt power cord from the electrical outlet, and disconnect the power
transformer connector from the power supply connector.
2. The battery compartment is located in the bottom of the power transformer. Slide the battery
cover over to access the battery compartment.
3. Snap the connection caps on the battery terminals. Place the batteries in the power transformer.
4. Slide the battery cover over the batteries.
5. Proceed to the
Operating Instructions
.
Power
Transformer
(2) 9-Volt
Alkaline Batteries
PowerReclineXR
®
Transformer Specifications:
Input: 100V-240V~, AC 50/60Hz, 1.5A
Output: 29V, DC 2A
Battery
Cover
Replace the power transformer batteries every six months and
after each power failure use. Under normal conditions, the battery
backup will operate the chair two times, but this performance
cannot be guaranteed.
