31
MAINTENANCE
Storing for 30 days or longer:
Drain all the fuel from the tank into a container approved for storing petrol. Press the primer bulb 3
- 4 times to remove the remaining fuel from the carburetor. Run the engine until it stops.
Transportation
(See Fig. 33)
■ Switch the product off and remove the battery pack before transporting it anywhere.
■ Attach transportation guards, if applicable.
■ Always carry the product by its handle. For convenience, secure the chest strap around upper
blower tube to prevent the blower tubes from scraping against the ground causing damage to
the unit(Fig.33).
■ Protect the product from any heavy impact or strong vibrations which may occur during
transportation in vehicles.
■ Secure the product to prevent it from slipping or falling over.
High Altitude Engine Operation
Initially your engine is configured for operation below 600m altitude. If the blower is being used
above 600m altitude, the engine must be re-configured accordingly. Operating the engine with
the wrong engine configuration at a given altitude may increase its emissions, drop fuel efficiency,
reduce performance and cause irreparable damage. Engines configured for high altitude operation
will need to be reconfigured for use in standard altitude conditions. Your qualified service center
should ensure that your engine is properly configured for your location.
THIS PRODUCT WAS MANUFACTURED WITH A CATALYST MUFFLER
Congratulations!
You have made an investment toward protecting the environment. In order to
maintain this product’s original emission level, please refer to the maintenance section below.
MAINTENANCE SCHEDULE
Maintenance Part
Inspect For
Damage
Before
Each Use
Clean Every
5 Hours
Replace
Every 25
Hours or
Yearly
Replace
Every 50
Hours
* CATALYTIC MUFFLER ASSEMBLY
Y
* AIR FILTER ASSEMBLY
Includes: Air Filter
Y
* CARBURETOR ASSEMBLY
Includes: Gaskets
Y
* FUEL TANK ASSEMBLY
Includes: Fuel Lines & Fuel Tank Cap
Y
Fuel Filter
Y
* IGNITION ASSEMBLY
Includes: Spark Plug
Y
