16
GB
PLEASE NOTE:
This water cleaner is equipped
with the A.S.S. (Automatic Stop System), which stops
the machine during the bypass phase. To start the wa-
ter cleaner, it is therefore necessary to set the switch
to the “ON” position; after that press the pistol trigger:
the Automatic Stop System will start the machine and
will stop it automatically when the trigger is released.
It is advisable to put on the safety catch of the pistol
trigger whenever the machine is stopped, in order to
avoid unintentional starting.
Any automatic start of the machine without
•
pressing the gun trigger is attributable to air
bubbles in the water or other similar pheno-
mena which do not imply the existence of any
defects in the machine. • Do not leave the ap-
pliance unattended during the standby mode
for more than 5 minutes. Contrarily, for the sa-
fety of the appliance it is necessary to re-turn
the switch into the OFF position.
Please check that the coupling of the high pres-
•
sure hose with the appliance and the gun sup-
plied as standard equipment is done correctly,
that is to say without any water leak.
If the appliance is equipped with a pressure regula-
tor:
when the pressure is set to minimum the A.S.S.
•
may not trigger. Therefore, do not allow the ap-
pliance to function in by-pass for more than 1
minute.
do not act on the gun lever too frequently (this
•
may cause a malfunction).
WATER SUPPLY
Minimum delivery rate: 12 l/min.
•
Water free from impurities.
•
Maximum intake water temperature: 40°C.
•
Failure to comply with the above conditions causes
serious mechanical damage to the pump and the
loss of warranty cover.
HIGH PRESSURE HOSE
WARNING: The high pressure hose is designed
and produced to withstand high pressures. To avoid
damage, it must be handled with special care.
Misuse may lead to premature breakages or damage
and cause the loss of warranty cover. (See illustra-
tions).
ELECTRICITY SUPPLY
The appliance’s electrical connection must com-
ply with the IEC 364 standard.
Before connecting the appliance, make sure that
the nameplate data are the same as those of the
electrical mains and that the socket is protected
by a differential security breaker with tripping sen-
sitivity below 0.03 A - 30 ms.
If the appliance’s plug is not compatible with the
•
socket, have the socket replaced with another
of suitable type by professionally qualified staff.
Never use the appliance in ambient temperatu-
res below 0°C if it is equipped with a PVC (H
VV-F) cable.
If an extension lead is used, the plug and socket
•
must be watertight and the cable must have the
dimensions shown in the table below.
230-240 V 100-120 V
2,5 mm
2
12 AWG
max 30 m
1543Rev01 Man XTR 14l_multi.indd 16
30-11-2009 18:14:47
