Superabrasive
Owner’s Manual Original Language – Lavina
®
32R-S-E
11/2014
23
OPTIKRIK II device (Fig.9.5.4). The static belt tension should be approximately 1150N, and 1450N for a new belt.
To change the tension, turn loose the bolts (Fig. 9.5.4 11) on
top of the puller, LOOSEN THE 5 BOLTS in the middle
(Fig.9.5.4 8) also loosen the sectors bolts (Fig. 9.5.4-8.1 and
Fig. 9.5.4-9).
Turn loose the secure nut on both forks (Fig. 9.5.4 7), begin to
tension with inner nut work similar on both belts (Fig.9.5.3).
After matching the right tension secure all previous bolts.
When replacing the belts, take off the tool holder and remove
the bottom cover. Release all tension completely. Replace the
belts, and put them on the right place in the grooves. Use (Fig.
9.5.4) and pull them at last over the tension rollers (Fig. 9.5.4-4,
9.5.4-5). Tension as earlier described.
SQUEALING NOISE
If the belt is making a squealing noise it means that the belt is
not aligned and is improperly tensioned.
9.6 REPLACING THE PULLEYS
Loosen the belt (see the previous paragraph). After removing the belts, unscrew the
four bolts of the pulleys on top of the disc (Fig. 9.6-1) and replace the pulleys.
9.7 REPLACING THE WHEEL
Lift the lorry on the side you need to change the wheel and place an wooden part so
the wheel is on the air. Unscrew the four bolts and take the wheel.
9.8 REPLACING THE BATTERY
9.9 MOTOR CONNECTION
In case of changing the motor, please check the cable connection to your motor(Fig.9.13).
Lavina
®
32R-S-E
The motor is connected in “Star” 380 Volt,
reminder for the wire connection of the motor.
Figure 9.6
Figure 9.7
Figure 9.8
Figure 9.9
Figure 9.10
Figure 9.11
Figure 9.12
Figure 9.5.4
Figure 9.13
