Superabrasive
Owner’s Manual Original Language – Lavina
®
32R-S-E
11/2014
21
Figure 9.2.7
Figure 9.2.8
Figure 9.2.9
Figure 9.2.10
9. TROUBLESHOOTING
INDEX OF PROBLEMS AND SOLUTIONS
9.1 REPLACING POWER CORD AND PLUGS
When replacing the power cord or plugs always use cords and plugs with the same specifications as the
original ones. Never use lower quality or different types of cords and plugs.
9.2 DISMOUNTING AND MOUNTING TOOL HOLDER
TO CHANGE BUFFERS AND SPIDERS, CHANGING V-RINGS AND FELT-RINGS
To check or replace the buffers and the spiders, the tool holders have to be removed. Remove the countersunk screws
on top of the buffer (Fig.9.2.1). Take the disc off (Fig.9.2.2), now the spider can be removed or replaced (Fig.9.2.3). By
loosening the four Hex cap bolts (Fig.9.2.4), the disc comes loose (Fig.9.2.5) and the buffers can be replaced
(Fig.9.2.6). Attention, when mounting always use, the “blue” thread locking adhesive, except on the bolts to lock the
buffers (Fig.9.2.5). Always use original bolts.
Depending on the number (3, 4, or 6) of buffers, the holder can be more flexible or rigid.
When the tool holder is dismounted, you can change the sealers (V-Ring and Felt-Ring).
Take out Felt-Ring, Adaptor and V-Ring. Before mounting check on which side the
adaptor is fitting, remember the correct side. Mount the V-Ring with the smallest lip of
the V to inside (Fig.9.2.7) just push the V-ring so the top is on the same level as the
pulley top (Fig.9.2.8). Than take the adaptor in the correct way and push the V-Ring
down with the adaptor (Fig.9.2.9). The lowest lip of the V-Ring should only barely touch
its gliding surface; also never push the V-Ring down with fingers. Mount now the Felt-
ring on top (Fig.9.2.10). Close the sealers with the cap (Fig.9.2.11).
Figure 9.2.11
Figure 9.2.1
Figure 9.2.2
Figure 9.2.3
Figure 9.2.4
Figure 9.2.5
Figure 9.2.6
