LAVAZZA Cap100US, Instructions For Installation And Use Manual

Page: 24 / 112

• • 24
F. 14
13.1.8 Cleaning the cappuccinatore
WARNING
Do not perform any cleaning operation of the cappuccinatore
when the machine is in “standby”.
The CAPPUCCINATORE must be cleaned each time it is used,
in order to avoid the solidification of deposits.
All removable components must be washed and rinsed in tap
water.
Warning! Danger of scalding. Hot water, steam sprays
and milk residue may spill out of the cappuccinatore during the
washing cycles. Do not place hands or other parts of the body
close to these parts until the cleaning cycle is complete.
The aim of this operation is to remove all the grease and scale deposits
that have formed during the flow and emulsion of the milk.
If the washing cycle is not performed, this would cause the deposits to
solidify, resulting in a loss of performance for the cappuccinatore.
WARNING
The operations described below should be performed with the
machine switched on and under pressure.
Periodic cleaning
This operation must be performed approximately every 30 minutes if the
cappuccinatore is used continuously.
- Remove the hose from the milk container and immerse it in cold water.
- Press the milk dispensing button to clean the cappuccinatore.
WARNING
It is recommended that the abovementioned cycle is performed
at least twice at intervals of one minute.
Cleaning of the cappuccinatore each evening
To be performed at the end of the working day.
- Fill a container with ½ litre of cold water and one dose of liquid
detergent (see product instructions).
- Remove the suction tube from the milk container and immerse it in the
detergent solution.
- By pressing the MILK button the water will flow out of the cappuccino
dispensing head. The message MILK will appear on the display.
Keep dispensing the milk beverage until the liquid has run out.
- The detergent will be drawn up automatically and flow out of the
cappuccinatore head.
- Once the washing cycle is complete, remove the chromed cover.
- Remove the cappuccinatore (see figure 14):
- Gently pull downwards and remove the connector of the milk tube
placed at the side of the cappuccinatore.
- Remove the cappuccinatore by pulling it from the front towards you.
- Dismantle the cappuccinatore completely and disassemble the five
parts.
- Prepare a new dose of detergent solution (as above) and immerse
the parts of the cappuccinatore.
- Wash each part with a sponge and remove all organic residue,
then re-immerse the cappuccinatore in the solution for at least two
hours.
- Replace the components.
- Put the cappuccinatore back in the machine, insert the milk pipe
connector placed at the side of the cappuccinatore and replace the
chromed cover in its seat.
- Clean the holes A and B using the appropriate bottle brushes (see
figure)
F. 13
A
B
- Rinse allowing at least ½ litre of cold water to be pumped
through the cappuccinatore.