Laurell Technologies
Operations Manual WS-650-Lite Series
Revision Date: 7/26/2011
All information contained in this manual is the property of Laurell Technologies Corporation® and is NOT to be edited, reproduced or
distributed without express written permission from a corporate officer.
60
the motor shaft adapter with the corresponding holes in the chuck; place the
bottom of the chuck over the motor shaft adapter and press down. Be sure to
firmly push the chuck into place.
Figure 3-13
INSTALLING PRESS-ON CHUCK
2. Screw Down Chuck:
The first step in removing the screw down chuck is to
remove the screw cover insert (see figure 3-14a). Once the insert is removed,
you will notice 2 screw heads (fig. 3-14b). Use a 9/64” Allen wrench to remove
both screws and gently pull the chuck upward until it is free of the motor shaft
adapter (fig. 3-14c). Replacing the chuck is done by aligning the 2 locating pins
on the motor shaft adapter with the corresponding holes in the chuck. Place the 2
screws into the chuck and firmly tighten the screws.
Do not force the chuck
into position, or hit it with anything to seat it (STOP immediately and
contact the factory for advice).
NOTE: Laurell Technologies Corporation does not warranty any damage to
the equipment caused by incorrectly installing a chuck or substrate.
Figure
3-14a
Figure
3-14b