Laurell Technologies
Operations Manual WS-650-Lite Series
Revision Date: 7/26/2011
All information contained in this manual is the property of Laurell Technologies Corporation® and is NOT to be edited, reproduced or
distributed without express written permission from a corporate officer.
44
Figure 3-12
Figure 3-12A
Figure 3-12B
The sensor “ON” state can be modified according to the input device
design. Spin 3000 can be configured according to the triggering device
which can be “normally on” or normally off”. See figure 3-12A, sensors A,
B and C are set to off and sensor D is set to on. The resultant action
associated with each sensor is shown in figure 3-12B. Sensor A will
provide a “Warn” or warning message if sensor A is triggered ON. Sensor
B will “Abort” the processor and provide an abort message if sensor B is
triggered ON. Sensors C will “Next” or go to the next step in the program
if sensor C is triggered ON. Sensor D will “Start” the processor if sensor D
is triggered OFF. Press the F2 key to exit a submenu.
Type
– Following the “Type” label is a field indicating sensor action. This line is
directly linked to the “Sens” line. Different sensor actions can be
