Laurell Technologies
Operations Manual WS-650-Lite Series
Revision Date: 7/26/2011
All information contained in this manual is the property of Laurell Technologies Corporation® and is NOT to be edited, reproduced or
distributed without express written permission from a corporate officer.
57
Motor / Maximum / Speed (Non)
- This field indicates the maximum speed that
the motor can achieve when vacuum is not required. This is a factory
setting.
Temperature
– This field shows the maximum temperature the motor can reach
before a fault condition is detected. This is a factory setting.
The 650S model does not have temperature readout.
Brushless
– This field shows the type of motor installed in the spin processor.
This is a factory setting.
Tune Motor
– This field is used when the brushless motor needs
tuning/calibration. This is an active field. Only factory trained personnel
perform tuning/calibration.
3.4.4.3 “INFO MODE” - ABOUT - DISPLAYED FIELDS – see figures 3-23A
To access the entire screen use the Right arrow
→
key to scroll to the right.
Model
– This field shows the spin processor model.
S/N
– This field shows the spin processor serial number.
Firmware
– This field shows the firmware revision number.
Controller
- This field shows the revision level of motor controller card.
Figure 3-23A
3.5 – PROGRAMMING THE 650 CONTROLLER
1. Turn on the spin processor. The 650 will initialize and default to the “Select
Process” screen.
2. If editing an existing program, highlight the desired program. If creating a new
program highlight the empty line. Press the “Edit Mode” key. If this is a new
program a program name will be assigned. The program name will appear on the
title line.
3. Use the navigation keys to move from line-to-line or the “Tab<” or “Tab>” key to
move to field-to-field. The “Tab” key enables the field to be editable. Make
changes to the field by using the
(UP) or
(DOWN) arrow keys.
4. Add or delete steps by highlighting the “steps” field with the “Tab” key and
increase or decrease the number.
