- 63 -
Scaling, Reading Coordinates of 2 Points Method
A scaling method, where the low and high input values are determined from
actual signals. A known low signal is first applied to the meter. That signal is
captured as the low input value, and the desired low reading is entered. A known
high signal is then applied. That signal is captured as the high input value, and
the desired high reading is entered. The meter then applies straight line fit. This
scaling method has the advantage of calibrating the transducer and meter as a
system. The actual voltage or current at either point does not need to be known.
The decimal point is set by the separate
dEC.Pt
menu item.
Setpoint
A value compared to the reading to determine the state of a relay. Term often
used interchangeably with “alarm setpoint.” The relay action can by
latching
or
non-latching
, utilize a
hysteresis band
, or utilize a
deviation band
. Hysteresis
bands and deviation bands are specified by two symmetrical limits around the
setpoint
.
Span
The number of
counts
corresponding to a given signal range.
Tare
A rear panel input which causes the display to be set to zero when the input is
momentarily tied to logic ground by a switch or is held at 0V (logic level true).
When the input is allowed to float or is held at +5V (logic level false), the meter
displays readings relative to this new zero. A common application is in weighing,
where an external Tare button is pressed to read the weight of an empty scale
(tare), and tare is then automatically subtracted as a constant from gross weight
for display of net weight. Tare can also be used for other applications where a
reading relative to starting point is desired.
Valley Display
The minimum (or most negative) reading since that minimum was last reset.
Reset can be via the meter front panel, an external input, or a software command.
The displayed value can reflect the filtered or unfiltered readings.
Zero
When used with process meters,
zero
is an adjustment so that a given low
transducer output reads zero on the meter.
Zero
is adjusted by programming
offset
.
