LAUNCH
TLT632AF INSTALLATION MANUAL
10
The depth of the hole depends on the length of the
bolt. It is advisable that the bolts above the base
frames should be around 30mm (1.2”).
Remove the dust from the holes.
Tap the bolt into the hole, insert and hit the core until
the bolt fully expands
Fig.9
6 Adjustment
6.1
Preparation
Lubricate the moving surface of the roller with #2
lithium lubricant. Lubricant should be applied
evenly from left to right.
Lubricate the joints of the lifts with #2 lithium
lubricant.
Check the oil tank for enough hydraulic oil.
6.2
Adjustment Procedures
Check if all the connection bolts are tightly fastened.
Press UP button, the platforms are raising; release
the UP button, the platforms stop raising. Press
DOWN button, the platforms are lowering.
If there is air in hydraulic system due to new
installation, air bleeding performance is needed.
The air in the master cylinder can be bled after the
platform goes up and down several times. The air
in the slave cylinder can be bled by following steps:
lift Master Platform close to the maximal height;
unscrew the two exhaust screws severally. Screw
the exhaust screw when the all the air are ejected.
Refer to Fig.4 and cylinder adjustment, adjust the
platforms to the same level.
Notice:
Attention should be paid to the position of oil pipes and
hydraulic hose when the platforms move to the minimal
height for the first time. Make sure they don not get stuck
with platforms moving downwards.
When bleeding the air in the cylinders, can NOT unscrew
the two exhaust screws at the same time or operate the lift
when the exhaust screws are unscrewing.
7. Safety Rules for Electrical
Control System
1.
Only personnel who are properly trained and have
adequate knowledge and skill should undertake all
electrical/electronic troubleshooting and repair.
2.
Do not alter or bypass protective interlocks.
3.
Before starting, read and observe all warning labels.
4.
When trouble shooting make sure the power source has
been disconnected and main switch has been locked.
5.
Take extra precautions in damp areas to protect you from
accidental grounding.
6.
Before applying power to any equipment it must be
established, without a doubt, that all persons are clear.
7.
Do not open the electrical control panel unless it is
necessary to check the electrical equipment.
8.
Do not alter the electrical circuits unless authorized to do
so by the manufacturer.
9.
When replacing electrical components, make sure they
conform to the manufacturer’s specifications, including
proper color coding.
