LAUNCH
Installation Instruction for Economical Symmetric Floor-plate 2-post Lift
10
6. Lift adjustment
6.1 Preparation before the
adjustment
z
Lubricate contact surface of the carriage and corners
of column with general-purpose lithium grease. All
sliding surface should be coated evenly from top to
bottom.
z
Fill hydraulic oil N32 or N46 to the oil reservoir of the
power unit.
6.2 Adjustment procedure
z
Check to see if the power supply is installed properly.
z
Check for the tightness of all the connecting bolts.
z
Press the starting button on the motor, and the
carriage rises; stop pressing the button, then the
carriage will stop. In order to lower down the carriage,
first pull the steel rope for the safety locks on the two
carriages one time for each. In case of failure to pull
the wire, re-pull after raising carriage a little. Press the
lowering handle on the power unit and the carriage will
be lowered; stop pressing the handle, then the carriage
will stop. In case of vehicle repairing, when the vehicle
is lifted up to the required height, first press the oil
release handle to actuate the mechanical safety lock in
order to ensure the safety operation.
z
The hydraulic system may contain air due to new
installation, to bleed the air, repeat the lifting and
lowering for several time
z
The adjustment is completed
